Rotate and move

rotate and move from point to point

rotate and move with direction

rotate and move from point to point and rotate and move with direction

These functions start the same tool with different type preallocation. A type switch can be carried out subsequently at any time via the context bar in the interactive environment.

With these tools, the objects are moved and rotated in one operation. These functions are especially useful for relocating yokes or relocating the shoulder seam.

rotate and move from point to point

For this function four points are to be clicked. The move vector is defined by its starting point and final point. The rotation angle is defined by the moved starting point and the final point of the rotation angle.

rotate and move with direction

For this function, 2 points and 2 lines are to be clicked. The rotation angle is determined by the angle between starting point of the move vector → direction 1 of the rotation angle and end point of the move vector → direction 2 of the rotation angle.

Step-by-step guide

functions of the context bar

If this button is active, the drag points of the active construction can be adjusted. Depending on the drag area, different drag points are available.

With this function, an existing displacement line can be deselected or a new displacement line can be selected . If the function is active, the points / lines for which a displacement line can be selected or deselected are marked. The cursor symbol indicates whether a displacement line already exists or not . Any line of the active part can be selected as displacement line. The right principle must be considered, as this determines the move direction.

An interactive rotate move transformation of type from point to point or with direction can be switched to the other type, after calling, at any time. Clicking on one of the two buttons in the context bar starts the click process where the end point for switch type: point to point or the direction for switch type: with direction are re-defined. The original starting point is always transferred during type switch.

With click new, the entire click process is gone through again. The basic elements of the active function, e.g. points, lines, directions are queried one after another. You can decide separately for each basic element whether to retain it or set it again. A right click accepts the original position/ setting.

The object selection remains intact with set new . It can be adapted via the function submit objects later .