Mitred corner, vent corner and hem corner single
As opposed to the simple corner, three or four lines are required for seam corners: the two seam lines and the two seam allowances.
Some of the seam corner can be called with the part assistant. Here, only one click is required.
The tools
mitred corner 
,
vent corner 
and
hem corner simple 
are all based on the same universal corner
These functions start the same tool with different type preallocation. A type switch can be carried out subsequently at any time via the context bar in the interactive environment.
Step-by-step guide- Select tool from the Toolbar.
-
Activate / deactivate
autostart
and
cyclic 
in the
context bar
.
- Click 1st allowance: cursor points towards the corner
- Click 1st seam: cursor points towards the corner
- Click 2nd seam: cursor points away from the corner
- Click 2nd allowance: cursor points away from the corner
Step-by-step guide
- Select tool from the Toolbar.
-
Activate / deactivate
autostart
and
cyclic
in the
context bar
.
- Click 1st allowance: cursor points towards the corner
- Click 1st seam: cursor points towards the corner
- Click 2nd seam: cursor points away from the corner
- Click 2nd allowance: cursor points away from the corner
Step-by-step guide
- Select tool from the Toolbar.
-
Activate / deactivate
autostart
and
cyclic
in the
context bar
.
- Click seam allowance: cursor points towards the corner
- Click seam: cursor points towards the corner
- Click 2nd seam: cursor points away from the corner
- Click 2nd allowance: cursor points away from the corner
See Order of clicking:.